Powering on the System

• If the touch screen is blank, touch anywhere on the screen to begin. Press the Single Page Controls button when prompted. You should see a menu similar to the one in the photo above. Note: If you see a different menu after touching the screen, press the Back To Menu button (bottom right) and then select Single Page Controls.
• Press the System On button. (top left)
• To turn on the projector, press the Power On button in the projector controls area. (This is circled in red in the photo above) The projector may take up to 45 seconds to warm up.

Choosing an Input

• Locate the input selector (This is the purple area in the photo above)
• To use the Computer, press the Comp 1 button (This may also be labeled Computer 1 or Pc). Make sure the computer is powered on.
• To use the VCR, press the VCR button (Make sure there is a tape inserted and the power on the VCR is on)
• To use the Document Camera, press the Doc Cam button. (Make sure the power switch on the side of the doc cam is turned on)
• When using a laptop, press the Comp 2/Laptop button.

Note: To control the VCR/DVD from the touch panel, press the VCR controls button on the top right and you will see the VCR controls appear below.

Powering off the System

• Press the System Off button. When prompted with a confirmation message, press Yes. This will also turn off the projector.